Liquid filling machine daily maintenance tips

In recent years, with the continuous improvement of living standards, people's demand for food, medicine and daily chemical products is increasing, and relevant manufacturing enterprises are also developing in the higher requirements of the market. At present, the use of liquid filling machine on the market is more and more broad, and the problems encountered in the use of equipment are increasingly sharp. Therefore, in order to better production of enterprises, it is very necessary to carry out related maintenance.

1. Before using the filling machine, bottle brushing machine and bottle flushing machine, it should be installed first and then tested. Before debugging, read the instructions carefully and prepare the tools used.

2. After the installation of the machine, bottle brushing machine and bottle flushing machine, the filling track and bottle receiving tray shall be levelled, the liquid storage barrel shall be filled with materials, and all electrical switches shall be in the closed position.

3. Insert the filling container into the fixture box, connect the external power supply, the power socket must be a three-pin socket, and there is a reliable grounding wire, to prevent the leakage of electricity to the case, switch the power switch of the machine to ON, the power indicator is ON.

4. Support plate will support the filling rack, with fingers. Move the positioning sleeve on the filling head, the positioning sleeve should be able to move up and down flexibly, among which the filling
Needle exposed or retracted without obstruction.

5. Switch under the liquid storage barrel to the open position, so that the material can flow into the total metering pump A, according to the total amount of each container filling, adjust the screw on the crank, turn the knob of the filling speed-regulating board to about 20 degrees, and then switch on the filling speed-regulating board to the open position.

6. When the liquid flowing out of the filling head is set to a certain amount, tighten the liquid amount fine tuning nut, cover the filling head shell, and loosen the filling frame support plate.

In addition to the maintenance and maintenance of the liquid filling machine, it is also necessary to keep the filling workshop clean and tidy. Because it is very taboo in the production process that the production line cannot run normally due to the quality problems of the filling machine itself, it is necessary to pay attention to sterilization, ensure clean and low-temperature filling when using the filling machine.